To properly display this page you need a browser with JavaScript support.
1.2.1.2. Advanced Press Settings
Relative view Applies to the density relative measurement view.
When active measured data shows relative to target instead of the absolute density value.
Relative view
Absolute view
Perfecting Press Setup It is recommended to activate when configuring the press as a perfecting press.
In the measurement view the control buttons move to the right side to gain more space in height:
Compact view Side ink keys without measurement are not displayed in order to get a more compact measurement data view
Hide active
Side ink keys without measurement data are omitted and not displayed.
Hide inactive
All ink keys from press setup are shown even when no measurement data is available for side ink keys.
Same color When active the software allows to use a specific color in more than one print unit
Auto transfer After scanning a press sheet the software automatically transfers data to InkZoneLoop/console for color-control.
Sync command Activate when InkZoneLoop is used. During the scan operation InkZoneLoop synchronizes its ink key position with the press.
Color bar position Select from the drop down menu one of the two options:
When selecting always centred
The option centred and shifted
Scan error detection Enter a density value to detect wrong scan data. When the scan data exceeds the setup value, the key will be not regulated.
Sample:
Target density setup = 1.55
Measurement = 0.3
Setup "disable key for out of range density " = 0.85
Difference of target / measurement = 1.55 - 0.3 = 1.25
The difference 1.25 exceeds the setup value 0.85. The ink key will be not regulated
An ink-key affected by the "out of range" value is shown with a red warning triangle and is not regulated.
Regulation strength A general regulation change for all units.
Return to System Setup
