With InkZoneLoop installed on the same computer, enable the application in IZMove here.
All measurement data created by InkZoneMove is sent to the selected scan data folder to be processed by InkZoneLoop.
Setting: Disable key for out of range density
Set a density threshold to detect wrong scan data. When the scan data values exceed the threshold will cause no regulation for this particular ink-key.
Sample:
Target density setup = 1.55
Measurement = 0.3
Setup "disable key for out of range density " = 0.85
E-Mail recipients Create an alias with one or a group of e-mail recipients. For a group of recipients, use a semi-colon to separate the mail addresses.
An alias is either internal or external. This helps avoiding mistakes when sending reports.
The rule is that e-mails defined as internal can be send always whereas external addresses are sent only when customer name from the job setup matches the e-mail alias name.
InkZoneKomoriConnect links to the Komori PDCS closedloop application
1
Komori CLC program
Set the path to the Komori CLC program. Usually it is located in folder C:\PDCS
2
CLC version
Select 3 or 4 (double check what is installed)
3
COM port
COM port used by the CLC program
4
Closedloop mode
Semi- and full auto. Standard is semi auto which requires the operator to confirm ink-key changes at the console desk. The setting Auto changes ink-keys immediately after transfer.
5
Wait for both sides...
Enable when using a perfecting press. Data is sent to press when both sides are scanned
When using an IZSwitchbox than configure the parameters here:
1
IP address
set IP address , usually 192.168.0.99
2
Relay channel
usually channel 1 is used
Use job name information from Komori KMS:
1
Path
Select the path to the status folder within KMS
2
Project and job name
Form the IZMove job name by project and job name from KMS
