1.3. Press preparation

1.3. Press preparation
1

Edit

1. Edit
Job name. Can be modified here.
2

Reset

2. Reset
Clear the current color to press unit assignment
3

Job information

3. Job information
Job information. Drag and drop from here a color to the press unit. C M Y K colors are automatically assigned to the unit defined in the press setup. A spot color is typically assigned by selecting drag and drop.
4

Assign to press

4. Assign to press
Assigns C M Y K, the process colors, to the press units. The standard color to unit assignment from the InkZone press setup is used.
5

Ink-key profile

5. Ink-key profile
Preview of the ink-key profile and the raw plate coverage.
6

Absolute ink-key change

6. Absolute ink-key change
Increase and decrease ink-key values absolute.
7

Relative ink-key change

7. Relative ink-key change
Increase and decrease ink-key position relative.
8

Ductor / Sweep

8. Ductor / Sweep
Increase and decrease ductor / sweep in absolute mode
9

Press setup

9. Press setup
Selected ink assignment.
10

Curve name

10. Curve name
Active paper calibration curve, used for the ink-preset.
11

Apply curve

11. Apply curve
By default, the button is in mode apply calilbration curve to ink-coverage. The ink-key profile shown above is the data to be transferred to press.
Toggle with the button between plate coverage and ink-key profile data.
 
Apply curve active: shows ink-key profile for press
 
Apply calibration curve not active: shows plate coverage
 
12

Transfer to press

12. Transfer to press
Transfer job to the press console.
13

Go to Job list

13. Go to Job list
14

Perfecting press

14. Perfecting press
See the job setup for a perfecting press here: 1.3.2. Perfecting job