1.6.1.1. Filter

Note: only available in conjunction with InkZoneLoop
1.6.1.1. Filter
1

Filter setting

1. Filter setting
Select and modify filter set
2

Selected filter

2. Selected filter
Applied filter set
3

Delta Density

3. Delta Density
Tolerance for density. The ink-key is used for the linearization when the calculated density difference is within this tolerance.
4

DeltaE of Lab

4. DeltaE of Lab
Tolerance for DeltaE. The ink-key is used for the linearization when the calculated DeltaE is within this tolerance.
5

Target density

5. Target density
Target density. By default, the target density from the measurement file is used. This is valid when the value is set to 0.
6

Modify filter

6. Modify filter
Currently used filter setup
7

Open filter

7. Open filter
Create and modify linearization filter
 
1
List with all filters
 
 
2
Return to main
 
 
3
Delete
 
 
4
Rename
 
 
5
Duplicate
 
 
6
Confirm change
 
 
 
 
 
 
8

Calibration by filter

8. Calibration by filter
Green dots meet the filter criteria and are used to recalculate the calibration curve whereas a red dot is omitted for the recalculation.
9

Go to Preview

9. Go to Preview