1.6.1.1. Filter

Note: only available in conjunction with InkZoneLoop

Filter setting

Select and modify filter set

Applied filter set

Tolerance for density. The ink-key is used for the linearization when the calculated density difference is within this tolerance.

Tolerance for DeltaE. The ink-key is used for the linearization when the calculated DeltaE is within this tolerance.

Target density. By default, the target density from the measurement file is used. This is valid when the value is set to 0.

Currently used filter setup

Create and modify linearization filter

Green dots meet the filter criteria and are used to recalculate the calibration curve whereas a red dot is omitted for the recalculation.