2.1.4.6.1. Add new Colour during Job Setup - Method 1
InkZone allows to add new spot colours to a spot calibration targetset during job setup in two different ways.
See the step by step instruction for the first method :
1) Load the job to the units and press SAVE
|
2) Select unit with the spot color
3) Press "Add spot to new spot targetset" and select curve set
|
4) Select the spot targetset to where the colour will be added.
|
5) Selected spot color targetset from step 4 . Indicator new curve shows up 6)
7) Continue with Close and 8) Save
|